Car alarm MITSUBISHI ASX 2011 A26.26
Transcript
Car alarm MITSUBISHI ASX 2011 A26.26
Car alarm Tipo di autovettura ed anno di produzione Scheda numero MITSUBISHI ASX 2011 A26.26 LOCATION OF THE CAR ALARM CONTROL UNIT Compact control units and sirens: Fastened using a stirrup on the original bolt located on the cooling-off liquid basin behind the headlamp, passenger side. Modular control units and accesories: under the dashboard, driver side. CAR ALARM SUPPLY Positive: White wire on the 2-pin Black connector in the fuse box under the dashboard driver side. Negative: Connect to the manufacture’s set-up under the kick plate, driver side. POSITIVE IGNITION KEY (+15) Grey wire (pos. 3) on the 15-pin White connector in the fuse box under the dashboard driver side. IMMOBILISER Starter Motor: Information not available REMOTE CENTRAL LOCKING (Connection for RF remote controller alarm only) Information not available ARMING OF PASSIVE TYPE ALARM (Connectin with alarm armed by vehicle’s original remote control) Follow the method of connections attached DIRECTION INDICATORS ONLY FOR DISPOSED ALARM Blinker Control (negative signal): Light Green wire (pos. 17) on the 24-pin White/Black connector in the fuse box under the dashboard driver side. Feedback: Green wire (left) (pos.12) or Purple (right) (pos.11) wire on the 20-pin White connector in the fuse box under the dashboard driver side. DOORS AND BOOT PROTECTION Doors: Yellow wire (front driver) pos.8, Green wire (fron passenger) pos.12, Light Blue (rear passenger) pos. 16, Red wire (rear driver) (pos. 1) on the 16-pin Brown/Black connector in the fuse box under the dashboard driver side.Separate lines with diodes. Boot: Pink wire (pos.3) on the 16-pin Brown/Black connector in the fuse box under the dashboard driver side. If you fit the dedicated alarm, doors and boot switches are detected by the CAN line BONNET PROTECTION Bonnet: Pink wire (pos. 12) on the 16-pin White/Black connector in the fuse box under the dashboard driver side HORN Yellow wire (pos. 13) on the 16-pin White/Black connector in the fuse box under the dashboard driver side 27/09/2010 rev.00Le informazioni riportate su questa scheda sono da considerarsi indicative e da verificarsi prima di eseguire ogni collegamento in quanto il costruttore puo,’ in qualsiasi momento , introdurre modifiche. In ogni caso la MetaSystem declina ogni responsabilità per eventuali danni arrecati alla vettura da un montaggio errato. Car alarm Tipo di autovettura ed anno di produzione Scheda numero MITSUBISHI ASX 2011 A26.26 FITTING INSTRUCTIONS FOR EASYCAN DIGITAL ALARM After completing connections, set the control unit for 30B MITSUBISHI “1” type controls. (See LINKING UP THE VEHICLE CAN in the fitting instructions for details of this procedure) Use the Car Alarm Programmer Remaining connections see previous diagnam. FUNCTION COLOUR CABLE ALARM COLOUR CABLE CAR POSITION ON THE CAR CAN H Black/Red Red 23 CAN L Black/Purple Pink 22 24-pin White connector behind the dahboard directly (image 1) Image 1 27/09/2010 rev.00Le informazioni riportate su questa scheda sono da considerarsi indicative e da verificarsi prima di eseguire ogni collegamento in quanto il costruttore puo,’ in qualsiasi momento , introdurre modifiche. In ogni caso la MetaSystem declina ogni responsabilità per eventuali danni arrecati alla vettura da un montaggio errato.