user manual for the VIA chipset version without the game\MIDI port

5.1 channels sound card
SC-5.1-1
5.1 channels sound card
5.1 channels sound card
Disclaimer
•
We spared no efforts to make sure that the information in this manual is correct and
complete. However no liability is accepted for any errors or omissions. Gembird
Electronics reserves the right to change the specifications of the hardware and
software described in this manual without prior notice.
•
No part of this manual may be reproduced, transmitted or translated in any language
in any form, by any means, without the prior written permission of Gembird
Electronics Ltd.
•
Gembird Electronics makes no warranties for damages resulting from corrupted or
lost data due to a mistaken operation or malfunction of the product, the software,
personal computers or peripheral devices.
Gembird® is a registered trademark of GMB Tech (Holland) bv.
Other names or products not mentioned above may be registered trademarks or
trademarks of their respective owners.
Copyright © 2007 Gembird Electronics Ltd. All rights reserved.
5.1 channels sound card
SC-5.1-1 User manual
Introduction
Thank you for buying the Gembird® 5.1 channels sound card! This manual will help
you install and use it properly.
Features
•
2/4/6 channel speakers mode. Supports 2/2.1/4/4.1/5.1 speakers
•
Full-duplex playback and recording
•
Superior audio fidelity
•
High quality headphone amplifier
•
Enhanced microphone input sensitivity
5.1 channels sound card
Specifications
•
Supports 6 channel output
•
Fully compliant with AC97 Revision 2.3
•
Superior audio fidelity
•
Independent 20 bit ADC and 20 bit DAC
•
Provide 96K/20 bit Multi-channel analog output
•
High quality headphone amplifier
•
Enhanced microphone input sensitivity
•
4-bit 3D depth control
•
Channel swapping
•
Supports EAPD control
•
PCI Rev. 2.2 compliant with bus mastering modes
•
ACPI compliant power down management
•
Chipset VT1723+1617
5.1 channels sound card
System requirements
•
Windows® 98SE/ME/2000/XP/Vista
•
DirectX 8.1 or above
Sound card layout
5.1 channels sound card
The rear panel of card has the following jacks:
1.
Mic In
2.
Line In
3.
Line Out
4.
Surr Out
5.
CEN/LFE
6.
J10 Analog CD|IN Port (Signals: L-G-G-R)
5.1 channels sound card
Installation
•
Locate an available PCI slot on your computer, and insert the 6 Channel Sound
Card into the slot. Fasten the card to the case using a screw
•
Start your PC. Windows® will detect the Sound Card, find a “PCI Multimedia
Audio Device” or “Multimedia Audio Controller” device. Click the “Cancel” button
to cancel the driver installation for the device at this moment
•
Place the Driver CD into the CD-ROM drive and start “setup.exe” on it, if the
installation is not started automatically
•
Follow on-screen instructions to complete the software installation
•
Restart your system