volkswagen transporter t5
Transcript
volkswagen transporter t5
Tel. +39 075.5280260 Fax +39 075.5287033 Via Pizzoni 37/39 06132 Perugia ITALY www.umbrarimorchi.it [email protected] ISTRUZIONI DI MONTAGGIO FITTING INSTRUCTIONS INSTRUCTIONS DE MONTAGE MONTAGEANLEITUNG INSTRUCCIONES DE MONTAJE DISPOSITIVO DI TRAINO TIPO TOWING BRACKET TYPE DISPOTIF DE REMORQUAGE TYPE ANHAENGEVORRICHTUNG TYP DISPOSITIVO DE CAREO TIPO 43051 PER AUTOVEICOLI FOR CARS POUR AUTOS FUR KRAFTAHRZEUGE PARA AUTOVEHICULO VOLKSWAGEN TRANSPORTER T5 TYPE 7HC, 7HM, 7HKX0, 7HK, 7J0 CLASSE E TIPO DI ATTACCO CLASS AND HITCH TYPE CLASSE ET TYPE DE CROCHET KLASSE UND BEFESTIGUNGSART CLASES DE ACOPLAMIENTO OMOLOGAZIONE CARICO VERTICALE MAX S VALUE MASSE VERTICALE MAXIMUM ZUL. STUETZLAST CARGA MAX. VERTICAL HOMOLOGATION HOMOLOGATION ZULASSUNG APROBACION e3 00 – 7189 F 2003→ S = kg 120 (DIR. 94/20/CE) VALORE D D VALUE VALEUR D D WERT VALOR D 14 kN D = 14 kN COPPIA DI SERRAGGIO PER VITI (8.8): TORQUE SETTINGS FOR NUTS AND BOLTS (8.8): COUPLE DE SERRAGE POUR VIS (8.8): SCHRAUBENANZUGSMOMENT (8.8): MOM. DE PRESION PARA TORNILLOS Y TUERCAS (8.8): Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 M6 = 10 Nm M10 = 55 Nm M14 = 135 Nm M8 = 25 Nm M12 = 85 Nm M16 = 200 Nm P. 1 / 6 SAFETY INSTRUCTIONS Make sure that the towbar is suitable for the vehicle before starting the installation. For safety, all work involving towbar installation (incl. electrical components) must be undertaken by skilled technicians. Damaged components must be replaced with manufacturer’s spares and fitted by qualified staff. It is forbidden to make any modification or structural repair to towing assembly. The towball must be kept clean and lubrificated. For added safety, his diameter (50 mm) must be checked at regular intervalls. If the towball measures less than 49 mm after selected readings across the diameter, the towball must be replaced with a new one. After 1000 km of towing, check torque settings for nuts and bolts, in accordance with the table. Umbra Rimorchi cannot be held responsible for any defects in the product caused by fault or by any injudicious use whatever of the user or a person he is liable for. Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 P. 2 / 6 FITTING INSTRUCTIONS 43051 VOLKSWAGEN TRANSPORTER T5 • Remove all mastic from contact points then paint with anti-rust paint. The necessary holes are already existing • • Remove bumper. Remove the bumper beam and the B polystyrene covering that is on the bumper beam. Discard the bumper beam. Remove the spare wheel. Remove the plastic covering from under the rear of the vehicle. Remove the towing ring and the muffler support on the right side Remove and discard the inner supports of the chassis rails both right and left. Cut covering B as per dimensions as showed and locate it on the upper part of the cross bar fitting it with double-sided tape or glue If the vehicle has parking sensors remove the plastic covers on the cross bar (position X). Locate item A referring to holes 01 and tighten. Tighten all bolts and nuts as per torque settings Connect the wirings to the socket Cut the lower plastic covering where it interferes with the system as showed. Re-fit the towing ring and the muffler support. Re-fit the plastic lower covering. Re-fit the spare wheel Re-fit bumper. • • • • • • • • • • • • • • Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 P. 3 / 6 Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 P. 4 / 6 Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 P. 5 / 6 Cod. 43051 - Volkswagen Trasporter T5- v. 1.0 01/01/2011 P. 6 / 6