regolatore elettronico di velocità eeid

1
223
REGOLATORE ELETTRONICO DI VELOCITÀ EEID
EEID – ELECTRONIC SINGLE PHASE
CARATTERISTICHE
INDEPENDENT DRIVE
Per la regolazione di ventilatori e aspiratori
FEATURES
Variazione continua della• Independent
velocitàcontrol of fan speed. Infinitely variable from max to
min with off position
• Supply
230 VAC,
50/60 Hz,minima
1 Phase
Trimmer per la regolazione
della
velocità
•
•
•
•
IP54 Surface & IP44 Inset ingress protection rating
Two wire control
Clear indication light
minimum speed pre-set to 20% via
Regolatore elettronico per la Commissioning
variazioneadjustable
continua
della
internal potentiometer
• Fuse
5*20mm, spare
velocità di rotazione di motori
alimentati
a included
230V, con
• RAL9010 white ivory enclosure and face. Internal polyamide.
corrente a regime di 2 ampere
massimi in servizio
• Max ambient temperature: 50°C
continuo.
DESCRIPTION
Trimmer per la regolazione della
minima.
Our EEIDvelocità
drive is a compact
wall mounted speed controller
for single phase voltage controllable motors (230
Adatto per montaggio sia addesigned
incasso
(IP44) che in
VAC, 50/60 Hz). It varies the output voltage by using a optotriac
224
superficie (IP54).
phase angle control.
status
is indicated
by an LED,
while a hand
Custodia esterna in plasticaOperational
di colore
bianco
avorio
(RAL
controlled dial provides an on/off switch and the means to
9010); interno in poliammide.
infinitely control fan speed.
Suitabledi
for funzionamento.
inset or surface mounting with the splash-resistant
Un led arancione indica lo stato
SCHEMIWIRING
ELETTRICI
DIAGRAM
housing provided.
Massima temperatura ambiente: 50°C.
RANGE AND MOTOR PROTECTION
To ensure correct drive selection, please choose a drive that has
an amp rating that is equal to or above the fan motor full loadISOLATION AND ISOLATION AND WIRING (SEE
DIMENSIONI
(mm)
DIMENSIONS
AND WEIGHTS
current (FLC).
DIAGRAM ON PREVIOUS PAGE)
65
If motors are fitted with thermostat (Tk) overheat protection, we
A safety isolator/disconnect switch should be installed on the
32 controller type instead of our
the use of24our EEDS
mains electricity side of all motor drives; Please refer to SISO
EEID.
24 recommend
82
product.
EEID1A
EEID2A
EEID4A
EA900100
EA900101
EA900102
Current rating (A)
0.1 - 1.0
0.2 – 2
0.4 – 4
Fuse (A) 5*20mm
F1.25A H
F2.5A H
F5.0A H
Ingress Protection
IP44/54
IP44/54
IP54*
50 x 50
MODEL
Part
We recommend three wire control for increased speed stability
and low speed starting.
6
CHANGE OF FUSE
Break (Isolate) mains voltage. Undo control dial by first turning it
1 - Power
supply 230
50 Hz
to the right
beyond
endVAC,
stop
and then pull towards you.. Remove
2 - 230 VAC non-regulated output for connecting valve, dampers
1 -the
Alimentazione
elettrica
50 Hz Change fuse.
nut. Remove fuse holder 230
with VAC,
a screwdriver.
N - Neutral
in
reverse
order.
only recommended
2 Replace
- Uscita
230 VAC
regolata
perUse
il collegamento
di 3 -components
Regulated
outputnon
to motor
4 - Fuse valvole,
holderfast,
with spare
fuses
(Approved,
with high breaking
lampade,
serrande
ecc. capacity).
62 only
*Surface mount
62
5 - Minimum speed adjustment trimmer (pre-set to 20%)
N - Neutro
6 - Control light
MOTOR PROTECTION
3 - Uscita regolata al motore
If motors are fitted with thermostat (Tk) overheat protection it is
Products in bold are available from our UK Distributors on next
delivery,
4 -day
Portafusibili
con fusibile di scorta
to use the EEDS range to utilise this feature.
if ordered by 4pm. Please call to confirm availability on 01206recommended
222 555.
Fläkt Woods
5 - Trimmer per regolazione velocità minima (preimpostata al 20%)
WARRANTY
9513 GB 2015.08
Specifications are subject to alteration without notice
6 Any
- Spia
funzionamento
modifications
or alterations to the product relieve the
manufacturer of all responsibility. The manufacturer bears no
responsibility for any misprints or mistakes in this data, and
modifications or improvements to the product can be made at
any time after date of publication.
All dimensions shown in mm
DATI
TECNICI
MODEL
Part
EEID1A
Modello
Net Weight (g)
210
Gross Weight (g)
235
EEID2
EEID2A
EA900101
Alimentazione
elettrica 215
V/Hz/fasi240
230/50/1
EA900100
EEID4A
EA900102
Corrente
300 max
nominale
(A)
325
2
COMPATIBILITY
Our EEID Speed controller is suitable for use with single phase
Fläkt
Woods
08.04.2016
voltage
controllable motors.
Temperatura
MAINTENANCE
Grado di
Peso
max esercizio
protezione
(g)
In normal conditions our controllers
are
maintenance-free.
If
(°C)
external surfaces requires light cleaning, please use a dry
50
240
or slightly damp cloth. If heavy cleaning is needed, then we
recommend the use of a non-aggressive cleaning product.
Particular attention should be paid to ensure that no fluids enter
Le controller.
specificheOnly
sono
soggettethe
a variazioni
senzamains
preavviso.
the
reconnect
controller tothe
electrical
supply when it is completely dry.
IP44/IP54