MP1 SuperAntenna
Transcript
MP1 SuperAntenna
www.i0jxx.com [email protected] Portable HF Antenna Super Fox MP1 SuperAntenna N° 4 Styles 28 cm 8 – 10 - 12 – 15 mm Ø Slaider Plastic screw Link Coil 80 m 32 cm Start to make the antenna from the base, by screwing together all sections, as shown on the picture on the left. Fix the antenna and connect the wire radials included in the box, in order to work on 40 m. It is advisable to add one 10 m long wire radial whereas a 20 m one for the 80 m band. Use “at least” 5 m of coax cable between the antenna and the RTX. Use the coil of 80 m band “ONLY” if you want to work on the above metioned frequency; on all other frequencies do NOT fix the 80 meter band coil. To use the antenna on 2 m (144 ÷ 146 MHz), all the advanced styles (N° 4 styles) are to be removed and the entire flowing tube is to be lowered. In order to use the antenna in 50 MHz, remove TWO advanced styles and lower the entire flowing tube, leaving a space of 1 or 2 mm between the coil and 2 flowing tubes (approximately ½ link on sight). Frequency 28 MHz 24 MHz 21 MHz 18 MHz 14 MHz 10 MHz 7 MHz 3.5 MHz Links 4-5 6 8-9 14 19 37 68 - 70 57 Base 32 cm 15 mm Ø To obtain a better S.W.R. it is possible to adjust ½ link, simply by turning the spider up to the desired adjustment. Point to fiexd radials MAX power 150 watt www.i0jxx.com [email protected] Antenna HF Portatile Super Fox MP1 SuperAntenna N° 4 Stili 28 cm. 8 – 10 - 12 – 15 mm Ø Tubo scorrevole Montare l’antenna partendo dalla base, avvitare a mano gli stili come mostrato nella figura. Fissare l’antenna e collegare i radiali di 4 metri forniti, per operare in 40 m. si consiglia di aggiungere un radiale in filo da 10 metri; mentre per gli 80 m. aggiungerne uno di 20 m. Collegare “almeno” 5 metri di cavo coassiale tra l’antenna e l’RTX. Montare la bobina degli 80 metri “SOLO” se si vuole operare su questa frequenza; in tutte le altre frequenze la bobina degli 80 metri non va montata. Per utilizzare l’antenna in due metri (144 ÷ 146 MHz), togliere tutti gli stili superiori (N° 4 stili) ed abbassare tutto il tubo scorrevole. Per utilizzare l’antenna in 50 MHz togliere DUE stili superiori ed abbassare tutto il tubo scorrevole, lasciando tra la bobina ed il tubo scorrevole 1 o 2 mm. (circa ½ spira a vista). Vite di fissaggio Bobina Bobina 80 m 32 cm Base 32 cm 15 mm Ø Frequenza 28 MHz 24 MHz 21 MHz 18 MHz 14 MHz 10 MHz 7 MHz 3.5 MHz Spire 4-5 6 8-9 14 19 37 68 - 70 57 Per ottenere un migliore S.W.R. è possibile anche regolare ½ spira, semplicemente ruotando il tubo scorrevole, lasciandolo al punto di accordo. Potenza MAX applicabile 150 watt PL259 Punto di fissaggio radiali