ALOS PRISM triplet and stereopairs to build Digital Surface Model
Transcript
ALOS PRISM triplet and stereopairs to build Digital Surface Model
ALOS PRISM triplet and stereopairs to build Digital Surface Model Valerio Baiocchi, Baiocchi Maria Vittoria Milone, Milone Martina Mormile Area Geodesia e Geomatica, Geomatica DICEA, DICEA Sapienza Università di Roma, Roma Via Eudossiana 18, 18 00184 Roma, Roma Tel. Tel 0644585068, 0644585068 fax 0664585515, 0664585515 e-mail, e mail valerio baiocchi@uniroma1 it [email protected] Introduction I the In th p present s tp paper p the th p phases h s s of f extraction t ti of f a DSM from f ALOS Prism P is stereopairs st p i s and d triplets t ipl ts are illustrated. ill st t d Images represents a coastal area that spans from the city of f Pescara P sc t the to th city cit of f Ortona O t n (Abruzzo (Ab uzz region, i n Italy). It l ) The availability of PRISM stereopairs and triplets is recent but no longer possible cause platform ended its activities last year. year In this paper accuracy of produced DEMs is compared with heights from terrestrial LIDAR survey. survey Specific characteristic of the images acquired for this study is the possibility to compare two stereopairs between them and the stereopairs with the triplet. triplet Stereopair and triplet data Table 1 - Images characteristics Fig. 1 – Stereopair and triplet coverage Table 2 2- Accuracy and precison of image orientation Fig. 2 –DSM obtained from the stereopair width approximately 45 KM Results of differentiation between DSM Stereopair height and LIDAR height on more than 86000 points using bilinear interpolation Fig.3 g – LIDAR points, p image g width approximately pp y 2.5 km M Mean 0 000 0.000 Standard deviation 0.938 Maximum difference 5.825 Minimum M n mum difference ff r n -3.949 .9 9