ACCESSORY FOR PANEL MOUNTING OF DIN
Transcript
ACCESSORY FOR PANEL MOUNTING OF DIN
D01281 - ACD 655 Eng. COSTER 03.04.06 MZ ACCESSORY FOR PANEL MOUNTING OF DIN-6 SERIES X… MODULAR ENCLOSURES ACD 655 Eng. 1. APPLICATION 3. INSTRUCTION FOR INSTALLATION Proceed as follows: • Separate the base (11), including the basic printed circuit (10) of the DIN-6 device from the cover., • Withdraw from the basic circuit the loose female connectors from the fixed male connectors (9), • Insert the DIN-6 base in the DIN 144 x 144 enclosure (5), securing it to the rail with the release lever provided (12), • Make the electrical connections with the loose female connectors, taking care to leave sufficient wire protruding from the these connectors from the housing in the device, • Insert the female connectors in the male connectors of the base circuit of the DIN-6 device, • Insert the square enclosure in the space provided, • From the rear secure the square enclosure with the two fixing brackets (7), tightening up the screws provided (8), • Replace the cover of the DIN-6 device on its base, • Complete the installation by applying the front panel (1), securing it with the latch (6) and tightening the two screws (4). +0 Where previous devices are being replaced the cutout is already available, whereas for new installations the cutout must be prepared as shown in the diagram on the right. . 138 - 1 mm 2. CUTOUT FOR FLUSH MOUNTING overall dimension 150 mm ACD 655 accessory is an adaptor which permits replacing electronic devices in flush-mounted DIN 144 x 144 enclosures by the new devices in DIN-6 enclosures. It can also be used as a new mounting if it is wished to install a DIN-6 device flush-mounted. +0 138 - 1 mm overall dimension 150 mm 1 – Facia 2 – Securing screws for DIN-6 cover 3 – DIN-6 device 4 – Facia securing screws 5 – DIN 144 x 144 enclosure 6 – Securing pawls for facia 7 – Securing brackets DIN 144 X 144 enclosure 8 – Securing screws for brackets 9 – Fixed connectors on printed circuit 10 – Basic printed circuit 11 – DIN-6 base 12 – DIN-6 base release lever COSTER CONTROLLI TEMPERATURA ENERGIA COSTER TECNOLOGIE ELETTRONICHE S.p.A. Sede Legale: 20132 Milano - Via San G.B. De La Salle, 4/a Head Office & Sales Via San G.B. De La Salle, 4/a 20132 - Milano Orders Reg. Off. Central & Southern Via S. Longanesi, 14 00146 - Roma Shipping Via Gen. Treboldi, 190/192 25048 - Edolo (BS) E-mail: [email protected] 2 Tel. +39 022722121 Fax +39 022593645 Fax +39 0227221239 Tel. +39 065573330 Fax +39 065566517 D 01027 MZ 03.04.06 Tel. +39 0364773200 Tel. +39 0364773202 Web: www.coster.eu We reserved the right to make changes without notice